DigiDesign ADAT Bridge I/O Manual 

19, Chapter 2: Connecting Your Studio 15 Synchronization Connections For frame-accurate or near-sample-accurate transfers, you need a third-party synchro- nization peripheral. Synchronizing the two systems lets you transfer tracks back and forth between Pro Tools and your ADATs in perfect sync. You…

40, ADAT Bridge I/O36 In OMS Setup (Macintosh Only): 4 On your computer, open the OMS Setup application and configure the BRC and your MIDI interface. (If you choose Alesis in the Manuf pop-up menu, and BRC in the Model pop-up in this dialog, the appropri- ate settings will be configur…

55, Chapter 9: Synchronizing Pro Tools and ADAT using an Opcode Studio 64XTC 51 chapter 9 Synchronizing Pro Tools and ADAT using an Opcode Studio 64XTC Figure 7. Connecting a Studio 64XTC to an ADAT Bridge, Pro Tools and ADATs MIDI INMIDI OUT 22A3 4 1 2 3 411A Computer to Pro Tools c…

46, DigiDesign ADAT Bridge I/O ADAT Bridge I/O42 Hardware Setup The JL Cooper DataSync2™ translates the ADAT-proprietary ABS time reference sig- nal embedded on ADAT tapes into MTC. The MTC is sent to your computer and used to trigger Pro Tools from the ADAT transport. This allows synchronized audio playback, recording…

37, Chapter 5: Synchronizing Pro Tools and ADAT with an Alesis BRC 33 chapter 5 Synchronizing Pro Tools and ADAT with an Alesis BRC Figure 3. Wiring example for a BRC-equipped system Computer to Pro Tools card word clock out from ADAT Bridge I/O to BRC 48 kHz word clock in Pro Tools …

21, Chapter 3: Using Your System 17 chapter 3 Using Your System If you are using the ADAT Bridge as your primary Pro Tools audio interface and do not need positional sync between Pro Tools and ADAT, then the primary configuration instructions are all you need. If you are using a synchroni…