Digimax 210 Operation & User’s Manual

6, RF DigiMax 210 Rear View Cut Link 1 for 16°C minimum set point Cut Link 2 to display cooling symbol instead of heating symbol Batteries Link 2 Link 1 3 2 1 Terminal block a) Commissioning The RF DigiMax 210 is required to be matched with the RF- Max receiver. This is to ensure …

7, Digimax 210 RF Receiver Led’s (indicators) : Red Led : ‘flashing’ : indicates receiving an RF signal ‘steady on’ : indicates a fault condition e.g. RF signal not being received ‘slowly plusing’ : indicates a valid install code has been received Green Led : ‘steady on’ : - indicates…

3, III. Installation : Please read all installation instructions before proceeding. The RF DigiMax 210 works with batteries. It does not need any wire. If you wish it to replace an old cable thermostat, isolate and secure the old wires, which are useless now. Do not forget to cut the power when y…

12, Extending the SC9000 security console with a Digimax 210 thermostat. If the console has not received any more messages from the thermostat, the LCD display will read [PROBLEM ZONE X] Programming the “differential temperature” on the console The thermostat needs to be registered wi…

11, Extending the SC9000 security console with a Digimax 210 thermostat. The HF DigiMax 210 thermostat does not require extra wiring and has a radius of 30 m. The appliance is equipped with a protected HF code. This code is registered with the SC9000 during installation. This code …