Megger BMM2000 Series Operation & User’s Manual

6, Display: Audible: <5Ω continuous bleep <3kΩ short bleep >3kΩ no bleep Resistance Tests (kΩ) This is a low voltage (5V) low current (25µA) test for sensitive electronic equipment. It operates in the same way as the continuity ranges. 1. Set the selector switch to kΩ.…

3, Live Circuit Warning When more than 25V (10V on 10V insulation range) is applied to the terminals in the insulation ranges, the instrument defaults to a voltmeter and gives an audible warning if a test is attempted.On all other switch positions except OFF/V when approx 10V is applied the defaul…

13, REPAIR AND WARRANTY The instrument circuit contains static sensitive devices, and care must be taken in handling the printed circuit board. If the protection of an instrument has been impaired it should not be used, and be sent for repair by suitably trained and qualified personnel. The protection…

1, M BMM2000 Series Insulation Multimeters User Guide SAFETY WARNINGS • Safety Warnings and Precautions must be read and understood before the instrument is used. They must be observed during use. • The circuit under test must be de-energised and isolated before connections are made exc…

5, Continuity Testing (Ω) (See fig.2) The continuity tests are activated when the probes make contact of less than a few kΩ. The tests apply a constant current and measure the resulting volt drop across the circuit under test. The test operates without the need to press the TEST button. When the te…

12, Megger BMM2000 Series Complies with the following parts of EN61557, Electrical safety in low voltage systems up to 1000V a.c. and 1500V d.c. – Equipment for testing, measuring or monitoring of protective measures:- Part 1 – General requirements Part 2 – Insulation resistance Part 4 – Resista…