Mellanox Technologies MHRH29B-XTR Operation & User’s Manual

15, ConnectX®-2 VPI Single and Dual Port QSFP InfiniBand and Ethernet Adapter Card User Manual Rev 1.6 Mellanox Technologies 15 2. Over-temperature This equipment should not be operated in an area with an ambient temperature exceed- ing the maximum recommended: 55°C (131°F). To guarantee proper…

54, Rev 1.6 Mellanox Technologies 54 B.3 QSFP Connector Pinout Figure 16: Connector and Cage Views Table 25 - Connector Pin Name and Number to Signal Name Correspondence Connector Pin Number Connector Pin Name Port A Signal Name 1 GND GND 2 TXN_2 Tx2n 3 TXP_2 Tx2p 4 GND GND 5 TXN_4 Tx4n 6 TXP_4 Tx…

59, Mellanox Technologies MHRH29B-XTR ConnectX®-2 VPI Single and Dual Port QSFP InfiniBand and Ethernet Adapter Card User Manual Rev 1.6 Mellanox Technologies 59 Figure 19: Placing the Bracket on the Card Gaskets in place on the bracket. 6. Make sure that the LEDs are aligned onto the bracket holes. 7. Use a torque…

18, Adapter Card Interfaces Rev 1.6 Mellanox Technologies 18 2.1.5 LED Assignment There are two I/O LEDs per port, green and yellow, located on the I/O panel. Table 8 outlines the different LED functions. Figure 5: LED - Port Association Table 8 - Physical and Logical Link Indications LED Functi…

27, ConnectX®-2 VPI Single and Dual Port QSFP InfiniBand and Ethernet Adapter Card User Manual Rev 1.6 Mellanox Technologies 27 3 VPI Adapter Card Installation 3.1 Hardware Requirements Before installing the adapter card, please make sure that the system meets the hardware require-…

50, Rev 1.6 Mellanox Technologies 50 A.7 Board Mechanical Drawing and Dimensions All dimensions are in millimeters. All the mechanical tolerances are +/-0.1mm Figure 12: Schematic of the Dual Port Adapter Card MHQH29C …