Mellanox Technologies MNPH29C-XSR Operation & User’s Manual

18, Adapter Card Interfaces Rev 1.6 Mellanox Technologies 18 2.1.4 I 2 C Compatible Interface A three-pin header on the card is provided as the I 2 C compatible interface. See Appendix A,“Specifications,” on page 34 for the location on the board. Figure 6: I 2 C Connector 2.2 Power All ada…

17, Mellanox Technologies MNPH29C-XSR ConnectX-2 Ethernet Card User Manual Rev 1.6 Mellanox Technologies 17 2.1.3 LED Assignment The board has I/O LEDs located on the I/O panel. The green LED, when lit, indicates that the driver is running and a valid physical connection between nodes exists. If the green LED is blin…

37, ConnectX-2 Ethernet Card User Manual Rev 1.6 Mellanox Technologies 37 Figure 14: Schematic of the ConnectX-2 Card MNPH29C Adapter Card A.4 EMC Certification Statements Table 12 lists the approved certification status per in different regions of the world. Table 12 - Adapter Cards Certificat…

24, Driver Software and Firmware Rev 1.6 Mellanox Technologies 24 Figure 8: Support Download Assistant 3.4 ConnectX EN PXE The Mellanox ConnectX EN PXE solution enables the booting of servers from an IP based LAN environment. To enable or disable PXE use the following procedure: The user must use t…

20, Adapter Card Interfaces Rev 1.6 Mellanox Technologies 20 76 VPD Keyword V0 STR Misc Information 78 Length 0x10 79 Data PCIe Gen2 x8 STR_SPC 95 VPD Keyword RV STR 97 Length 0x1 98 Data 0,97 %CS0 99 Large Resource Type VPD-W Tag (0x11) 0x91 100 Length [7:0] LSB 0x99 101 Length [15:8] MSB 0…

13, ConnectX-2 Ethernet Card User Manual Rev 1.6 Mellanox Technologies 13 1.2 Mellanox Part Numbering Legend Table 4 describes the Mellanox Technologies adapter cards part numbering legend. For example, the part number MNPH29C-XTR describes Mellanox Technologies’ ConnectX EN adapter card with tw…