Mellanox Technologies IS5025 Installation Manual

6, Mellanox Technologies IS5025 Rev 1.0 Mellanox Technologies 6 Step 3. Login (from serial terminal program) as admin and use admin as password. This starts the Mellanox configuration wizard. Step 1. Go through the Mellanox configuration wizard. Table 4 shows an example of a wizard session. Stop bits 1 Parity None Flow Control …

2, Rev 1.0 Mellanox Technologies 2 Tools and Parts Tools required and customer supplied parts Parts Included in the Installation Kit: Figure 1: Rack Installation Kit Parts Before you install your new switch, unpack the system and check to make sure that all the parts have been sen…

4, Rev 1.0 Mellanox Technologies 4 Step 5. Clip the 4 caged nuts into the holes in the rack you will be using to connect the rail slides. Check that both sides of the switch, left and right, are in the same position num- ber on the rack. Step 6. Clip 4 more caged nuts into the holes in the ra…

3, Rev 1.0 Mellanox Technologies 3 Figure 2: Which Side of the Rack Do You Want the Connectors? • Do you want the connector side recessed in the rack to allow for larger cable bending radius? • Will the connector side be recessed past other equipment in the rack and will this be problem…

9, Rev 1.0 Mellanox Technologies 9 Step 2. Before attempting a remote (for example, SSH) connection to the gateway, check the eth0 interface configuration. Specifically, verify the existence of an IP address. To check the current eth0 configuration, enter the following commands: bridge-112428> e…

5, Rev 1.0 Mellanox Technologies 5 Step 14. Check the Status LEDs and confirm that all of the LEDs show status lights consistent with normal operation. Step 15. You can start connecting all of the cables to the switch. Grounding the Switch You must install an external ground to all IT comp…