Allied Telesis AT-2400 Series Installation Manual

62, Linux 62 Installing the ATNIC Driver for AT-2450/AT-2451, AT-2700/ AT-2701 Series, and AT-2745/AT-2746 Series PCI Ethernet Adapters This driver supports dynamic loading and unloading via the KLM support provided by Linux. As a result, you must custom build the driver for the partic…

11, Network Adapter Card Installation Guide - Book II 11 Document Conventions This guide uses several conventions that you should become familiar with before you begin to install the product. Note Notes provide additional information. Warning Warnings inform you that performing or …

88, AT-2971 Solaris Sparc 88 If there are any remaining connections to any of the GE adapters (see Steps 1 and 2), you will see the following error messages: “Device busy Cannot unload module: skge Will be unloaded upon reboot.” 4. Load the driver again into the system with the fol…

66, Allied Telesis AT-2400 Series Linux 66 ❑ rx_flow_control Enables or disables receiving flow control (pause) frames. This parameter is used together with auto_flow_control. The valid values are: 0 pause receive disabled (default) 1 pause receive enabled if auto_flow_control is set to 0, or pause receive advertised if auto…

98, AT-2971 Solaris Sparc 98 Example: Instance number of the adapter: 0 First VLAN to create: Vlan_0_DevNum, Vlan_0_ID Second VLAN: Vlan_100_DevNum, Vlan_100_ID Third VLAN: Vlan_200_Dev_num, Vlan_200_ID ... and so on. Instance number of the adapter: 1 First VLAN to cr…

7, Network Adapter Card Installation Guide - Book II 7 Chapter 7 AT-2971 Solaris Sparc ......................................................................................................................................................................................69 Installing a Solari…