Braeburn 1200NC Instructions Manual

1, WARNING Important Safety Information 1 Replacing Existing Thermostat © 2004 Braeburn Systems LLC • Patents Pending • All Rights Reserved. Pub. No. 1000-100-009 Builder Series Non-Programmable Thermostats Single Stage Heat / Cool Conventional and Heat Pump Multi-Stage 2 Heat /…

2, 2 3 Installing Your New Thermostat WARNING! Read BEFORE Testing Installation 2 cont. NOTE: If installing this thermostat in a new installation, locate the thermostat 4 to 5 feet above the floor in accordance with applicable building codes. Install the thermostat in a location that provides goo…

3, Braeburn 1200NC 4 Default Thermostat Settings Setting Temperature Differentials Programming User Settings 4 The default settings for the first and second stage differentials are compatible with most systems and applications. This is normally set at time of installation and usually does not require a…

4, 6 7 Compressor Protection Feature Low Battery Detection and Replacement This thermostat includes an automatic compressor protection feature to avoid potential damage to the system from short cycling. This thermostat automatically provides a 5-minute delay after turning off the cooling system outpu…

5, 8 9 Rc Rh G Remove Factory Installed Jumper MODEL 1000, 1000NC: Single Stage Conventional Systems (Dual Transformer) WYB O Fan Control Cool Control Cool 24 VAC Transformer Heat 24 VAC Transformer 120 Volt AC 120 Volt AC Hot Side Heat Transformer Hot Side Cool Transformer Heat Control R…

6, cont. Wiring Diagrams 7 R O Reversing Valve (Active in Cooling - See NOTE 3) B Y1 G W2 Transformer Common (See NOTE 1) 1st Stage Compressor Contact Emergency Heat Control 2nd Stage Heat Control Fan Control 24 VAC Hot 120 VAC Neutral See NOTE 2 MODEL 1200, 1200NC: Multi-Stage Heat Pump System…