Allied Telesis AT-8000S Cli Reference Manual

133, Power over Ethernet Commands Page 131 no power inline powered-device Parameters • pd-type—Specifies the type of powered device attached to the interface. (Range: 1-24 characters) Default Configuration This command has no default configuration. Command Mode Interface Configuration (Ethernet) m…

68, Page 66 Allied Telesyn AT-8000S Switch CLI Reference Guide show backup-config The show backup-config privileged EXEC command displays the backup configuration file contents. Syntax show backup-config Default Configuration This command has no default configuration. Command Mode Privileged …

36, Page 34 Allied Telesyn AT-8000S Switch CLI Reference Guide Syntax bridge multicast forbidden forward-all {add | remove} {ethernet interface-list | port-channel port-channel- number-list} no bridge multicast forbidden forward-all Parameters • add — Forbids forwarding all multi…

109, Line Commands Page 107 Default Configuration The default speed is 9600 bps. Command Mode Line Configuration (console) mode User Guidelines This command is available only on the line console. The configured speed is applied when Autobaud is disabled. This configuration applies only to the c…

262, Page 260 Allied Telesyn AT-8000S Switch CLI Reference Guide Parameters • access — Indicates an untagged layer 2 VLAN port. • trunk — Indicates a trunking layer 2 VLAN port. • general — Indicates a full 802-1q supported VLAN port. Default Configuration All ports are in ac…