GE Fanuc Series 90-70 Operation & User’s Manual

33, 2 Series 90–70 Remote I/O Scanner User’s Manual – July 199226 Power Supply Installation After setting the rack number selection jumpers, install the power supply as instructed in its datasheet. An AC power supply installs directly in the leftmost slot of the rack. For DC power sup…

55, 3 49Chapter 3 Remote I/O Scanner Operation Configuring Extra References Normally, there are no extra references configured for the Remote I/O Scanner, since that would consume extra references in the host CPU, making them unavailable for other modules. In addition, extra reference…

66, 4 Series 90–70 Remote I/O Scanner User’s Manual – July 199260 Using Auto I/O Map Use Auto I/O Map if you want to use the software’s automatic I/O mapping feature. With Auto I/O Map, the first I/O module of a given data type is assigned the same offset as the offset of the I/O map. Au…

129, 9 127Chapter 9 Remote I/O Scanner Datagrams Fault Byte 3 76 54 32 10 byte 2 Fault record number (always 0) Number of fault records Fault Bytes 4 and 5 Fault bytes 4 and 5 (bytes 3 and 4 of the datagram) identify the reference offset (within the Remote I/O Scanner itself) assigned to the faulted mo…

6, GE Fanuc Series 90-70 Contents vi GFK–0579B Series 90–70 Remote I?O Scanner User’s Manual – July 1992 Chapter 5 Logicmaster 90 Operation with a Remote Drop 77 . . . . . . . . . . . . . . . . Overview 77 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .…

28, 2 section level 1 1 figure bi level 1 table_big level 1 21 Chapter 2 Installation This chapter describes procedures for installing the racks and modules in a remote drop, grounding equipment, connecting the Genius bus, completing SNP connections, and attaching a programmer. …