Directed AM1 Installation Manual

25, © 2005 directed electronics, inc. 23 NNOOTTEE:: If the Unlock learn was unsuccessful, the Unlock procedure can be repeated by using the LOCK learn procedure, except that at step 4 press and release the inte- grated LED/Valet® switch TWICE. (The LED will flash in groups of two flashe…

31, © 2005 directed electronics, inc. 29 features #1 menu Factory default settings are shown in bboolldd . Feature steps 5 and 6 are related. Only if Auxiliary Output Enabled is selected in fea- ture 5 can either Auxiliary Output or Delayed Accessory Output be selected in fea- ture step…

18, Directed AM1 16 © 2005 directed electronics, inc. vehicles operate this way. If this is the case connect the RED wire to the passenger unlock motor wire. When testing this wire be sure that it shows 12V (+) ONLY when the unlock button on the factory transmitter is pressed the second time to unlock the pa…

17, © 2005 directed electronics, inc. 15 auxiliary harness wire connection guide auxiliary harness wiring diagram ___ ___ ___ ___ ___ ___ ___ auxiliary harness wiring guide HH22//11 BBRROOWWNN ((--)) hhoorrnn hhoonnkk oouuttppuutt:: This wire supplies a 200 mA (-) output that can be used …

36, 34 © 2005 directed electronics, inc. I can get into programming and change the feature settings, but when I use the remote the settings seem to change. • Are you using a binary, master dealer remote? Remember, you can program the settings using a master dealer remote. However,…

11, © 2005 directed electronics, inc. 9 4. Turn on the parking lights. If your meter shows (+)12V, turn off the parking lights and make sure it goes back to zero. 5. If it does return to zero, turn the parking lights back on and, using the dash light dimmer control, turn the brightness of th…