DKS 6002 Owner's Manual

23, 2.7 Secondary Entrapment Device Terminal Description 1. OPEN PHOTO-BEAM This input is only active when the gate is in the opening cycle. If the open photo-beam is activated during the opening cycle, the gate will stop. The gate will remain stopped until the photo-beam input is cleared, at w…

31, 3.5 Reverse Sensitivity Adjustment This vehicular gate operator is equipped with an inherent adjustable reverse sensor (Type A) that is used as the primary entrapment sensing system. Upon sensing an obstruction in either the opening or closing gate cycle, the gate operator will reverse direction…

25, 2.9 Battery and Solar Panel Wiring Batteries are required for the actuators to operate properly. Two 12-Volt 3.4 amp hour batteries are provided with the actuator control panel. Batteries should be replaced every two years on average. When replacing batteries, be sure to connect them in…

37, SECTION 5 – MAINTENANCE AND TROUBLESHOOTING Inspection and service of this gate operator by a qualified technician should be performed anytime a malfunction is observed or suspected. High cycle usage may require more frequent service checks. 5.1 Maintenance Schedule When servi…

5, IMPORTANT SAFETY INSTRUCTIONS WARNING - To reduce the risk of injury or death: 1. READ AND FOLLOW ALL INSTRUCTIONS. 2. Never let children operate or play with gate controls. Keep the remote control away from children. 3. Always keep people and objects away from gate. NO ONE…