Metrologic ARGUSSCAN MS7220 Installation And User Manual

35, 31 DEFAULT SETTINGS Many functions of the scanner can be "programmed" - that is, enabled or disabled. The scanner is shipped from the factory programmed to a set of default conditions. The default parameter of the scanner has an asterisk ( * ) in the charts on the following page…

30, 26 TROUBLESHOOTING GUIDE (CONTINUED) SYMPTOMS POSSIBLE CAUSE(S) SOLUTION Power-up OK and scans OK but does not communicate properly to the host. Com port not operating properly. Check to make sure that the baud rate and parity of the scanner and the communication port match and the…

25, 21 DEPTH OF FIELD BY MINIMUM BAR CODE ELEMENT WIDTH (BASED ON 100% UPC BAR CODES) Depth of Field (Default) Figure 13: Side View of Depth of Field Specifications subject to change without notice. Minimum Bar Code Element Width ABCDEF mm .13 .19 .26 .33 .48 .66 mils 5.2 7.5 10.4 13 19 26 …

18, Metrologic ARGUSSCAN MS7220 14 THE MULTI-FUNCTION BUTTON CHANGING THE BEEPER TONE A Short (<3 second) depression and the beeper tone will change. The new tone will be heard, followed by a short pause. Then two more of the new tones will be heard signifying the new setting has been stored in memory. The silent…

32, 28 APPLICATIONS AND PROTOCOLS The model number on each scanner includes the scanner number and factory default communications protocol. Scanner Version Identifier Communication Protocol(s) 7220 12 RS232, Light Pen, Keyboard Wedge, Stand- Alone Keyboard, OCIA, Low Speed Option The MS7220 with Bu…

9, 5 Figure 1: OCIA Interface OCIA INSTALLATION FOR OCIA INTERFACE To power the unit with an external power supply: 1. Follow the “Getting Started” steps on page 3. 2. Turn off the host system. 3. Connect the PowerLink cable to the jack labeled “OCIA ” on the MS7220. 4. Co…