Metrologic IS4320 ScanGlove Programming Manual

15, Metrologic IS4320 ScanGlove DF1 D81 D82 Recall Defaults 11 RS-232 Parameter - Data Bits RS-232 serial communication requires ASCII data to 8 Data Bits transmit in either 7 or 8 data bits. In addition, one parity bit will transmit. If necessary, scan the appro-priate bar code that matches your host device’…

28, ** EX1 EX2 CK2 CK1 LZ1 LZ2 R36 R37 R38 R39 Enter/Exit Program Mode 24 UPC-E Options Expand UPC-E When this option is selected, the scanner will expand UPC-E to the 12 digit equivalent UPC-A. ** Do Not Expand UPC-E UPC-E Check Digit On When this option is on, the scanner will transmit the UPC-E chec…

14, ** PA1 PA3 PA2 PA4 Enter/Exit Program Mode 10 RS-232 Parameter - Parity Parity is an additional digit that makes the number of bits in the ASCII code odd or even. The scanner’s parity must match the host’s parity. **Space Parity Select this option to make the parity bit always…

6, ** R18 R19 DF1 Enter/Exit Program Mode 2 Enter Program Mode **Ability to Enter Program When this option is selected, enter Mode After Any Scan programming by scanning the ENTER/EXIT PROGRAM MODE bar code after power up or during normal scanning operation. Enter Program Mode Only When this …

41, DF1 RS7 RS8 R24 R27 R28 R29 R33 R34 R35 R40 Recall Defaults 37 Reserved Codes Metrologic has reserved the codes on the following pages for features that will be added at a later date. Do not assign a function for any of the reserved codes. …