Generic TR 125 Service Manual

102, Generic TR 125 - 97 - XI Cylinder Head Preparatory data 11.1 Fault diagnosis 11.2 Cylinder Head/Valve 11.3 11.1 Preparatory Data Function of cylinder head: Cylinder head is used to seal cylinder and form a combustion chamber with piston t…

124, - 119 - Measure the thickness of friction plate with a vernier caliper. Allowable limit: Replace it when below 2.5mm. Check the flatness of the driven friction plate with the plug gauge. Allowable limit: Replace it if above 0.2mm. measure the thic…

106, - 101 - Measure the free length of the valve spring. Allowable limit: Spring: 37 mm Measure the outer diameter of the valve stem. Allowable limit: Intake Ф4.455 mm Exhaust Ф4.448 mm Check valve guide. Please eliminate the…

154, - 149 - (5) If the software interface cannot display real-time communication data in the case of power, it needs to continue the following work, under "Setup" check whether there is problem with COM port connection settings, and the usual settings are COM Port: 4, the Baud Rate: …

51, - 46 - 3.2.2 Wobbly Direction Handle z Damaged handle bearing z Not enough tyre pressure. z Front fork bent, front wheel shaft bent. z Distorted and crooked front wheel tyre. 3.2.3 Wobbly Front Wheel z Distorted wheel rim z Worn front wheel bearing z Defective front tyre z Unbalan…

117, - 112 - Measure Connecting rod small end ID. Allowable limit: Φ15.068mm Installation of piston Install location pin. Apply engine oil evenly on each piston ring and piston. Install piston to its place with bevel upward. Attention: Piston shall not be scratched and pist…