Dodge 2000 Durango Service Manual

1, Dodge 2000 Durango ENGINE TABLE OF CONTENTS page page 4.7L ENGINE..............................1 5.2L ENGINE.............................86 5.9L ENGINE............................135 4.7L ENGINE TABLE OF CONTENTS page page DESCRIPTION AND OPERATION ENGINE.................................2 ENGINE LUBRICATION …

22, TIMING CHAIN—MEASURING WEAR NOTE: This procedure must be performed with the timing chain cover removed. (1) Remove the timing chain cover. Refer to Timing Chain Cover in this section for procedure. (2) To determine if the secondary timing chains are worn, rotate the engine clockwise until maxim…

105, place, inspect to make sure seals are in place. Remove alignment studs if used. (9) The following torque sequence duplicates the expected results of the automated assembly system (Fig. 39). • Step 1—Tighten bolts 1 thru 4, in sequence, to 8 N·m (72 in. lbs.) torque. Tighten in alternating ste…

71, (2) Remove accessory drive belt refer to Group 7, Cooling System for procedure. (3) Remove A/C compressor mouning fasteners and set aside. (4) Drain cooling system. Refer to Group 7, Cooling System for procedure. (5) Remove upper radiator hose. (6) Using Special Tools 6958 Spanner with Adap…

4, 1 – LEFT CYLINDER HEAD OIL GALLERY 2 – OIL PRESSURE SENSOR LOCATION 3 – TO LEFT CYLINDER HEAD 4 – OIL FEED TO IDLER SHAFT 5 – OIL PUMP OUTLET TO BLOCK 6 – OIL PUMP 7 – TO CRANKSHAFT MAIN JOURNALS 8 – RIGHT CYLINDER HEAD OIL GALLERY 9 – TO RIGHT CYLINDER HEAD 10 – CYLINDER BLOCK …

45, NOTE: The cylinder head is attached to the cylinder block with fourteen bolts. (21) Remove the cylinder head retaining bolts. (22) Remove the cylinder head and gasket. Discard the gasket. CAUTION: Do not lay the cylinder head on its gas- ket sealing surface, do to the design of the cy…