ClearSounds CS2000M Owner's Manual

6, Small Headphone Jack Installation – for use with equipment that has a small headphone jack. Connect the Transmitter (A) directly into the equipment’s audio output jack as shown in Diagram 4. Large Headphone Jack Installation – for use with stereos that have…

5, Standard Installation – for use with TVs, VCRs, or stereos that have two audio output jacks. Connect the Transmitter (A) to the RCA/3.5mm Adaptor Cord (D) and then connect the cord (D) to the audio output jack as shown in Diagram 2. Be sure to connect the a…

3, ClearSounds CS2000M The transmitter sits on your audio source (TV/VCR, stereo, etc.) and transmits an audio signal via infrared light. The receiver in the headphones captures the infrared light waves and converts them back into sound. You adjust the volume on the cordless …

1, OWNER'S MANUAL WIRELESS TV LISTENING SYSTEM with Dual Ear Volume Control Model CS2000M 95 KHz Frequency CS2000MOwner'sMan.indd 1 2/1/08 3:46:54 PM …

7, jacks on the VCR. If your VCR has one audio output jack, use the RCA 3.5mm Mono Adaptor (F) instead of (D). See Diagram 6. Microphone Installation – for use when your equipment does not have an audio output jack. Connect the Transmitter (A) to the Microp…

2, INTRODUCTION Our wireless infrared system allows you to listen to your TV, Stereo, Radio, or any other audio source at a volume that is com- fortable for you without disturbing oth- ers in the room. Use it if you are hard of hearing or if you simply want to watch television when some…