Hobbico DIGITAL R/C MULTI-METER Operation Manual

1, PLEASE READ THESE OPERATING INSTRUCTIONS CAREFULLY. Misuse and/or abuse of this instrument may cause injury and/or damage to the meter or the equipment under measurement. Please read and follow all instructions carefully. Please inspect the meter and test probes for wear or abnormalities prior to e…

8, WARNING: Before attempting to replace the battery, first disconnect the test probes from any energized circuit and then disconnect the test probes from the instrument. 1. Disconnect the test probes from any energized circuit, and from the meter. 2. Turn the dial to the “OFF” position. 3. R…

10, being measured and work down from there. Note these areas of the selection range are red in color, to match the color of the proper jack in which the red test probe should be inserted for this type of measurement. CAUTION: To avoid possible electric shock, instrument and/or equipment d…

9, 4. Remove the battery from the battery clip. 5. Remove the fuse from the clips located in the center of the p.c. board. 6. Install the replacement fuse (making certain it is of the same specifications as the original fuse). Prior to inserting the fuse, make sure each clip is crimped so that t…

13, 5. For continuity measurements: A. Move the dial to the selection marked “DIODE” with the buzzer icon underneath. B. Touch the red and black probes together to confirm the audible buzzer sounds and that the LCD reads “.000”. C. Completely de-energize the circuit or devi…

15, Hobbico DIGITAL R/C MULTI-METER are not touching any live electrical circuitry to prevent accidental short circuits and possible damage to the meter and/or other equipment. It is always important to keep the probes completely clear of any live electrical circuitry when not in use. Problem: LCD is fading or does not display -…