Hobbico TACTIC TTX650 Instruction Manual

16, 16 V-tail: Elevator and rudder channels are mixed. Two servos are used in the tail – one for each control surface, with connections as shown in the graphic above. V-tail mixing controls the airplane’s “pitch” and “yaw” axis at the same time. If the elevator and rudder functions app…

32, 32 To select a switch to turn throttle hold on or off during fl ight, set the Control fi eld to ON. With the cursor next to CTRL, defl ect the switch that will control throttle hold. In one position the control will be ON. Moving the switch to the opposition will turn the control OFF. Move th…

11, 11 Fundamental settings for the transmitter are located in this menu. With the power switch in the OFF position, press and hold ENTER, turn the power switch ON and wait for the SYSTEM SETUP screen to show. Move the cursor and press ENTER to select any setting. Press or to change setting…

23, 23 The throttle cut function will only work when the throttle stick position is below the trig point. To set this point, move the cursor next to TRIG but do not press ENTER. Move the throttle stick to the desired position that will trigger the throttle channel to move to the cutoff position. …

25, Hobbico TACTIC TTX650 25 RUDDER MIXING Mixing the rudder channel to the aileron and/or elevator channels can be very useful for trimming an airplane to be neutral when using the rudder. Select the rudder channel to mix to the aileron or elevator channels as needed. This mix can be active at all times by not…

44, 44 FAILSAFE NOT WORKING CORRECTLY: Receiver is not properly linked to the transmitter – bind the Rx to the Tx and re-try. Check the channels which are programmed for transferring from Tx to Rx in the transmitter’s programming. Contact Hobby Services for further details. WIRELESS TRAIN…