Giant Factories water heater Owner's Manual

15, created. “Stacking” is the result of increased cycling of the burner and can produce very hot water tempera- tures at the hot water outlet. Always remember to check the hot water coming out of any faucet with your hand before use. This will reduce the risk of scalding-relate…

9, Giant Factories water heater is installed in the cold water inlet. Install a shut-off valve close to the water heater in the cold water line. It is recommended that unions be installed in the cold and hot water lines so that the water heater can be easily disconnected, if servicing is required. When assembling t…

8, 8 INSTALLATION INSTRUCTIONS 1) Vent pipe 2) Air intake pipe 3) Power vent assembly 4) Union 5) Cold water manual shut-off valve 6) Expansion tank 7) Temperature & pressure-relief valve 8) Overflow tube 9) Drain valve 10) Drain pan 11) Free-flowing floor dra…

13, 13 OPERATING INSTRUCTIONS Lighting the Water Heater Before lighting or re-lighting your water heater, make sure that you have read and understood all of the instructions and warnings in this man- ual and on your water heater. If you have any questions about lighting your water heater, immedia…

22, 22 STANDARD BASIC LIMITED WARRANTY ON RESIDENTIAL GAS WATER HEATERS GENERAL The manufacturer warrants that, subject to verification of a warranty claim within the warranty period as described below, it will take the necessary corrective action to either repair or replace a water heater or comp…