Future light PHW-700 Operation & User’s Manual

9, 51838740X74NXS_V_1_0.DOC 32/92 Lamp adjustment The lampholder is aligned at the factory. Due to differences between lamps, fine adjustment may improve light performance. Strike the lamp, open the shutter, set the dimmer intensity onto 100 % and direct the light towards a flat surface (…

23, 51838740X74NXS_V_1_0.DOC 46/92 ♦ Press [ENTER], the display shows“S-XX”, “X” stands for the total amount of steps you want to save, so you can call up to 48 scenes in “RUN”. For example if the “XX” is 05, it means that “RUN” will run the first 5 scenes you saved in “EDIT”…

5, 51838740X74NXS_V_1_0.DOC 28/92 If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might damage your device. Leave the device switched off until it has reached room temperature. This…

6, Future light PHW-700 51838740X74NXS_V_1_0.DOC 29/92 Make sure that the area below the installation place is blocked when rigging, derigging or servicing the fixture. For overhead use (mounting height >100 cm), always fix the fixture with an appropriate safety-rope. Fix the safety-rope at the correct fixat…

3, 51838740X74NXS_V_1_0.DOC 3/92 INTRODUCTION ............................................................................................................................................. 49 INSTRUCTIONS DE SÉCURITÉ ..........................................................................…

24, 51838740X74NXS_V_1_0.DOC 47/92 Error Messages When you turn on the fixture, it will make a reset first. The display may show “XXEr” while there are problems with one or more channels. “XX” stands for the channels equipped with a testing sensor. For example, when the display s…