NetComm NB6 Operation & User’s Manual

44, 6. On the Configure LAN side Settings page, key in the IP address and subnet mask for your LAN. Check DHCP Server On box, and enter the start and end points, e.g.: Primary IP address: 192.168.1.1 Subnet Mask: 255.255.255.0 Start IP Address: 192.168.1.2 End IP Address: 192.168.1.25…

88, as 64 bit Wired Equivalent Privacy or WEP for short. The default 64 bit Hexadecimal WEP key is: a1b2c3d4e5 Select the WEP mode for the security function; there are two options, 64-bit and 128-bit. Before being transmitted, the data will be encrypted using the encryption key. For examp…

17, Function Color Definition Power Off Power is off. Solid Green Power is on and the device operates normally. Solid Red Power on self-test in progress The device enters the console mode of the boot loader. Power on self-test failure if the led always stays solid red.…

15, NetComm NB6 Function Color Definition Power Off Power is off. Solid Green Power is on and the device operates normally. Solid Red Power on self-test in progress The device enters the console mode of the boot loader. Power on self-test failure if the led always stays sol…

77, To add a new Inbound IP Filtering, click Inbound traffic in the item of Select the direction to filter packets on the IP Filtering page. Use the same way to add a new one as stated above. Quality of Service QoS (Quality of Service) is an industry-wide initiative to provide preferential treatm…

32, 4. On the General tab, check out the list of installed network components. Option 1: If there is no TCP/IP Protocol, click Install. Option 2: If you have TCP/IP Protocol, skip to Step 7. 5. Highlight Protocol and then click Add. 6. Click Internet Protocol (TCP/IP) and then…