Duratrax Evader EXT Assembly And Operation Manual

7, Duratrax Evader EXT 7 SPEED CONTROL TROUBLESHOOTING GUIDE NOTE: The Sprint 2 has built-in circuitry to sense an excessive heating condition caused by current overload. If the ESC overheats, it will automatically shut down, as indicated by fl ashing red and green LEDs. This is to protect all on-board components…

5, 55 Forward Reverse Throttle Tr i m Steering Tr i m Steering Servo Reverse Switch On/Off Throttle Servo Reverse Switch 6-CELL BATTERY INSTALLATION Battery Clip Battery Strap Battery Slot Battery Strap Post ALWAYS CHECK THE RADIO OPERATION BEFORE EACH RUN ! • Install the charged 6-cell battery…

10, 10 The following section is provided to help you with maintenance and repairs to your Evader EXT. Pay extra attention to the notes and tips for proper assembly. MAINTENANCE GUIDE Bulkhead, Bulkhead Brace, Front Suspension Arm, Front Shock Tower, Front Bumper 1. Attach the front bu…

14, 14 Slipper Clutch 1. Install the inner slipper plate (84) onto the top shaft (83). Make sure the notch in the inner slipper plate keys onto the 2x10 spring pin (116) in the top shaft. 2. Place the slipper pad (64) and outer slipper plate (85) onto the top shaft. Make sure the slippe…

11, 11 Steering Servo Saver Assembly 1. Insert the short servo saver post (99) into the right brass bushing (105) in the chassis. 2. Install two short ball studs (81) into the right servo saver (46) in the holes shown. 3. Insert a plastic bushing (48) into each end of the right servo saver. Ag…