Autopage MA-200 Installation Instructions Manual

4, Oct/23/2006 MA200 IN REV.A 4 Many motorcycles and recreational motorcycles do not have front running lights. If the motorcycle does not have front running light, you may want to use the separate left and right turn signal indicators for flash purposes. Connect one of the two White wire…

5, Oct/23/2006 MA200 IN REV.A 5 This will become a 1 second pulse ground by activate F button on transmitter for two seconds, the current capacity of this wire is 200 mA. This output can be programmed to provide the following type of output: 1 second pulse / latched / Latched with ignition / …

2, Autopage MA-200 Oct/23/2006 MA200 IN REV.A 2 INSTALLATION We recommend insulating all your soldered or crimped connections with heat shrink or electrical tape. We also recommend spraying silicone sealant on all your connections and plugs after they are connected and plugged in, spraying be…

3, Oct/23/2006 MA200 IN REV.A 3 WIRING DIAGRAM “Start” Black Antenna Wire LED Indicator Transmitter Antenna H1: Main 6 Pin White harness H2 : 7 Pin White Mini Connector Valet Switch H5 4 Pin Blue H6 2 Pin Blue H7 2 Pin White H1 6 Pin White H2 7 Pin White …

6, Oct/23/2006 MA200 IN REV.A 6 b. The system will advance to [2] LED flash, One chirp with a long chirp. (The factory default settings is always [1] LED flash, [1] chirp.) 4 Depress the transmitter button ‘A’ again to change the feature again. Simply keep re-depressing the transmitter…