Dwyer Instruments Series APM Instruction Manual

47, Analog Panel Meter Instruction Manual 47 Character Set for Engineering Units Display (d unit) The small display can be programmed to show engineering units or cus- tom legends using the following 7-segment character set: Display Character Display Character 0 0 k K 1 1 …

15, Dwyer Instruments Series APM Analog Panel Meter Instruction Manual 15 Note: Testing was conducted on APM meters installed through the covers of grounded metal enclosures with cable shields grounded at the point of entry representing installations designed to optimize EMC performance. Declaration of Conformity availa…

36, Analog Panel Meter Instruction Manual 36 Setting the Input Signal (input) Enter the Input menu to set up the meter to display current (mA) or vol- tage ( volt) inputs. The current input is capable of accepting any signal from 0 to 20 mA. Select current input to accept 0-20 mA or 4-20 mA s…

84, Analog Panel Meter Instruction Manual 84 3. The meter displays either current calibration ( C CAL) or voltage cali- bration ( v CAL), according to the input setup. Press Enter to start the calibration process. Example of Internal Calibration for current input: 4. The meter displays low in…

42, Analog Panel Meter Instruction Manual 42 Error Message (Error) An error message indicates that the calibration or scaling process was not successful. After the error message is displayed, the meter reverts to input 2 during calibration or scaling and to input 1 during interna…

63, Analog Panel Meter Instruction Manual 63 Latching Relay (Lt-Clr) Manual reset only after alarm condition has cleared Condition LED Relay Normal Off Off Alarm On On Ack (No effect) On On Normal On On Ack Off Off In this application, the meter is set up for manual reset only afte…