Glidecam Industries HD-1000 Manual 

27, 27 #7 Operating your Glidecam HD-2000 The Glidecam HD-2000 is designed to work correctly only when operated with two hands (see Photos 46 and 48). If you try to operate the unit with just your “Holding Hand,” the Camera will most likely drift aw…

11, 11 Connect the TELESCOPING POST to the BASE PLATFORM by tightly screwing the TELESCOPING POST onto the treaded stud sticking up from the center of the BASE PLATFORM. At this point, your Glidecam HD-2000 should look like …

3, 3 PLEASE NOTE Since the Glidecam HD-2000 is essentially the same as the HD-1000 and the HD-4000, this manual only shows photographs of the Glidecam HD-2000 being setup and used. The Glidecam HD-1000 and the HD-4000 are just smaller and larger versions of the HD- 2…

9, Glidecam Industries HD-1000 9 Camera Mounting Screws Counter Weight Plates ¼”Washers Black Bo…

24, 24 NOTE: LATER AFTER YOU ADJUST THE VERTICAL BALANCE OF THE HD-2000 YOU WILL HAVE TO GO BACK AND READJUST THE HORIZONTAL BALANCE AGAIN IN ORDER TO OBTAIN A TRUE FINE BALANCE OF THE WHOLE SYSTEM. BALANCING THE VERTICAL AXIS …

22, 22 When testing for correct horizontal balance you need to make sure that you pick up your HD-2000 from a flat and level surface (a table for example) and that you let the HD-2000 hang freely as you hold it as shown in Photo # 38. If the HD-2000 is balanced corr…