BayTech TX102 Owner's Manual

37, BayTech TX102 31 31 4.3.44.3.4 DIAGNOSTICS MODEDIAGNOSTICS MODE NOTE: Standard units support Remote Diagnostics mode only. Diagnostics mode allows the active terminal to perform various tests with a remote Telplex unit if a communication link is established. Multi- drop units also allow the same tests to b…

93, T Technical Support 9, 65, 66 Telephone line 1, 2 Telex 66 Terminal port 2, 6, 9, 17, 19-24, 26-31, 34, 37, 39-43, 52, 54, 57, 63, 72, 73 Terminals 1, 2, 17, 19, 61-63, 72 TX24 16, 74 TX60 1, 2, 31, 44, 57, 63-65 U,V Unit number 3, 7, 8, 11, 22,…

51, 45 45 To access Local or Remote Unit Configuration mode for either type of Telplex, use the following procedure: 1. Connect a dumb terminal or a computer emulating a dumb terminal to the desired terminal port (factory default is Port 1). Make sure your terminal device is configured t…

80, 74 74 MINIMUM CABLING UMINIMUM CABLING USING HARDWARESING HARDWARE HANDSHAKINGHANDSHAKING PC DTE TX104/TX108 DCE FEMALE DB-25 MALE DB-25 8 CTS 6 20 DTR 2 3 7 20 7 5 3 2TXD RXD SGND A.2A.2 BETWEEN TX104 OR TX108 ANDBETWEEN TX104 OR TX108 AND IBM IBM PC/AT (DE-9)PC/AT (DE-9) RECOMMENDED CAB…

85, A.4.2A.4.2 PRINTER/PLOTTER INTERFACEPRINTER/PLOTTER INTERFACE To interface a DTE printer or plotter to a TX102 terminal port, refer to Figure 13 for the correct adapter pinout. Refer to Appendix A.4.5 for the cable pinout to connect the adapter(s) to the TX102. A.4.3A.4.3 MODEM I…

77, 71 71 88 TECHNICAL SUPPORTTECHNICAL SUPPORT In the event that you have problems with the Telplex, BayTech has a staff of applications engineers on duty to assist you from 7 am to 6 pm (CST or CDT), Monday through Friday. When you call BayTech Tech Support, please have the following informa…