American Dryer Corp. AD-285 Installation Manual

4, WARNING The dryer must never be operated with any of the back guards, outer tops, or service panels removed. PERSONAL INJURY OR FIRE COULD RESULT. IMPORTANT PLEASE OBSERVE ALL SAFETY PRECAUTIONS displayed on the equipment and/ or specified in the installation manual included with the dr…

28, 24 American Dryer Corp. 113235-5 H. PREPARATION FOR OPERATION AND START-UP The following items should be checked before attempting to operate the dryer: 1. Read ALL “CAUTION,” “WARNING,” and “DIRECTION” labels attached to the dryer. 2. Check incoming supply voltage to be sure that …

39, American Dryer Corp. AD-285 113235 -5 www.amdry.com 35 SECTION VIII PROCEDURE FOR FUNCTIONAL CHECK OF REPLACEMENT COMPONENTS 1. Microprocessor Controller (Computer) Board a. Phase 7 Coin Models 1) Upon completing installation of the replacement microprocessor controller (computer) board, reestablish power to the dryer. 2)…

17, 113235 -5 www.amdry.com 13 VERTICAL VENTING When vertical single venting is used, the minimum duct size is 8-inches (20.32 cm), refer to Illus. B below, the ductwork from the dryer to the outside outlet cannot exceed 60 feet (18 meters), refer to Illus. B below. This calculation compensate…

37, 113235 -5 www.amdry.com 33 90 DAYS Inspect and remove lint accumulation in customer furnished exhaust ductwork system from dryer’s internal exhaust ducting. WARNING: THE ACCUMULATION OF LINT IN THE EXHAUST DUCTWORK CAN CREATE A POTENTIAL FIRE HAZARD. WARNING: DO NOT OBSTRUCT THE FLOW …

44, 40 American Dryer Corp. 113235-5 OPTIONAL MANUAL BYPASS Provisions are made in the dryer S.A.F.E. system for the installation of an optional manual bypass. Depending on the model dryer, the connections for the manual bypass are made at the “T” or “three way” fitting located i…