Koolspace chillR 100 Installation & Operation Manual

3, Koolspace chillR 100 SILICONE CAULKING PLYWOOD FLOOR VAPOR BARRIER INSULATION (MIN R-20) SUB-FLOOR (STUD LUMBER) ALTERNATIVE WALL CUTOUT (B) RECOMMENDED OVER THE DOOR CUTOUT (A) SEAL ALL JOINTS DOOR WITH AIRTIGHT SEAL ODORLESS WATERPROOF PAINT DRYWALL DRYWALL VAPOR BARRIER INSULATION ( MINIMUM R-20 ) …

5, 6 ~4~ ~5~ FOAM WOOD SPACER (COOL SIDE) Cripple Stud Cripple Stud Remove any Cripple Stud located in the center above door 3 Insert 5/8” FOAM (supplied) as a vibration isolator. Check for level and shim if necessary or to achieve 1” clearance from molding. Screw WOOD SPACER into Header …

11, ~10~ ~11~ CONDITION CHECK CAUSES AND SOLUTIONS COOLING UNIT DOES NOT RUN WHEN PLUGGED IN = = = = = = = = COOLING UNIT RUNS BUT DOES NOT COOL SUFFICIENTLY = = = = = = = = = = = = = Unit plugged in? Power supply operational? LED display functional and are fans running? Any evidenc…

4, ~4~ ~5~ PREPARE FOR OVER THE DOOR CUTOUT (A) Open drywall on warm side. Measure distance from HEADER to TOP PLATE and MOLDING. Follow the typical installation described in STEPS 2-6 if clearance is 10” and the HEADER is at least 3/8” higher than the molding. (SEE PROFILE) 1 THE FOL…

2, ~3~ READ BEFORE YOU START Koolspace wine cooling units must be installed precisely as directed in the Manual. DO NOT attempt to install this unit before reading the Manual! NEVER Install this unit through an exterior wall, NEVER to OUTDOORS! (Units must ventilate to an adjacent…