Go!Control 2GIG-CNTRL2 Manual, Installation & Programming Instructions

27, 25 Installer Programming Wired Sensor Programming Steps Q-2 Select wired sensor # (1-2) Two hardwired loops can be used as sensors with each Control Panel. The options for each wired sensor are programmed with sub-option questions. • Begin by entering the wired sensor number or select it usi…

37, 35 Installer Programming Q-52 Select AC loss reports to CS (0-1) DEFAULT: Enabled (1) AC power loss reports can be sent to the Central Station if the Control Panel loses AC power. • The default (1) allows AC power loss reports. • To turn off AC power loss reports, select disable…

49, 47 Notes _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _________________________________________________________________…

25, 23 Installer Programming Enter RF sensor (#) serial number (7 digits) DEFAULT: 0000000 RF sensor serial numbers can be manually entered or learned from the sensor. • For manual entry, enter the sensor number that was logged for the sensor being programmed. Use the SHIFT button to access alpha c…

17, 15 Programming Navigation Figure 39. Navigation Arrows & Go To Button Figure 40. Questions without Sub-options Figure 41. Questions with Sub-options Figure 42. Questions with Data to Enter Figure 43. Other Buttons Displayed When the installer is using the System Confi guration menus, the…

12, Go!Control 2GIG-CNTRL2 10 Installation Optional GSM Module Installation If using the optional GSM module and one of the GSM antennas. Refer to the following steps: 1. Plug the GSM module into the connector on the Control Panel’s circuit board. Secure it with the two screws. 2A. If using the Model 2GIG-ANT1…