Beltronics 904 Operating Manual

7, ” Any signal received while in this mode will result in an alert – BUT NO “BLOCKING” OF THE LASER SIGNAL WILL OCCUR. When no Laser signal has been detected for 60 seconds, a short “beep” will be heard, coupled with FULL illumination of the green power on LED. This FULL illumina…

8, taken seriously. There are limitations to LIDAR equipment. LIDAR is much more sensitive to inclement weather conditions than RADAR, and a LIDAR gun’s range will be decreased by anything affecting visibility such as rain, fog, or smoke. A LIDAR gun cannot operate through glass…

10, Problem LaserPro™ 904 does not appear to be ON Solution: • Check that the P/V control is turned ON. • Check that the vehicle ignition is ON. • Check all connections. Problem LaserPro™ 904 gave no alert when a police car was in sight Solution: • Officer may not have the L…

5, Button Functions 1. P/V Button: Press once to activate power to LaserPro ™ 904*. Press and hold to cycle the volume control. * Depending upon the type of installation, LaserPro ™ 904 may be powered ON when your vehicle ignition is ON; and turned off, when your vehicle ignition is OFF …

6, Beltronics 904 General Operation Once you have BEL LaserPro ™ 904 properly installed, you’re ready for unencumbered travel. Assuming LaserPro ™ 904 is “hard wired” into your vehicle’s electrical system, each time you start your vehicle, LaserPro ™ 904 will start up. Conversely, each time your shu…

12, 1 Year Limited Warranty 1. This warranty covers all defects in material and workmanship. This warranty does not apply if the unit has been subject to physical abuse, improper installation, modification, or if the housing or serial number of the unit has been removed. 2. The enforceability …