Minka-Aire ARTEMIS Instruction Manual

20, 11 Fig. 20 WARNING: Shut off the power supply before removing or replacing lamp. In handling of halogen bulb, care should be taken not to touch it with your bare hands. Oil residue will shorten the life of the halogen bulb. If you accidentally come into contact, wipe thoro…

9, 3 Tools Required: Phillips screw driver; slotted screw driver; step-ladder; wire cutters; electrical tape. INSTALLING THE FAN MOUNTING OPTIONS If there isn't an existing mounting box, then read the following instructions. Disconnect the power by removing fuses or turning off circuit breakers…

16, Minka-Aire ARTEMIS 7 Step 1. Tuck connections neatly into ceiling outlet box. Step 2. Slide the canopy up to ceiling and over the two screws on hanger bracket. Rotate canopy clockwise, next, while holding the canopy with one hand, slide the canopy cover over the screws and rotate clockwise until tight. Note…

17, 8 Fig 17 Align and engage the top holes from one of the blades to the upper blade holder tabs. Carefully align the bottom holes from the blade to the holes from the lower blade holder. Secure blade with 3 screws provided. Follow the same process for the remaining two blades. (Fig. 17) Al…

21, 12 OPERATING THE REMOTE CONTROL/WALL CONTROL Restore Power to Ceiling Fan. A. Buttons: These buttons are used to set the fan speeds as follows; = Low Speed = Medium Speed = High Speed B. Button: This button turns the …

13, Step 3. Receiver to House Supply Wires Electrical Connections: Connect the WHITE wire (Neutral) from the outlet box to the WHITE wire marked "AC in N" from the receiver. Connect the BLACK wire (Hot) from the outlet box to the BLACK wire marked "AC in L" from the r…