J&J Electronics Color Splash Installation And Operation Manual

2, J&J Electronics Color Splash Color Splash ® LED POOL AND SPA LIGHT FIXTURES Available in 120VAC and 12VAC models Color Splash LED Pool and Spa light xtures offer superior, color illumination for your pool and spa. This owner’s manual contains important information on installing and using your new Color S…

4, 4" Min. 48" Min. 18" Min. Top of Lens to Water Level 8" Min. Junction Box or Low Voltage Transformer to the Max. Water Level of Pool To: GFCI, Circuit Breaker, and Power Source Rigid Conduit #8 AWG Ground Connector Bonding Lug is Located at Rear of Niche Coil 4 ft. o…

5, 2. At the junction box, cut the cord. Be sure to leave at least six (6) inches of cord for making connections. 3. Carefully strip the outer cord jacket to expose six (6) inches of the underlying three insulated wires. 4. Connect these three (3) wires to their corresponding juncti…

6, pg 5 Installation of this light must be completed by a licensed or certied electrician or a qualied pool professional in accordance with the National Electrical Code and any applicable local codes and ordinances. Improper installation may result in death or serious injury to pool u…

1, Technical Support Phone: 800.735.4553 ext. 242 For more information about this or other J&J Electronics lighting products, please visit www.jandjpoolspa.com Color Splash ® LED Pool and Spa Light Fixture Installation and Operation Guide …

10, pg 9 DEACTIVATION THE COLOR LOCK FEATURE Turn the pool light power off and then back on again within 2 seconds. Color Splash will resume light show. MEMORY MODE When your Color Splash LED light xtures are turned off for more than 10 seconds, the solid color or light show on display…