J&J Electronics PureWhite Installation And Operation Manual

2, PUREWHITE POOL AND SPA LED LIGHT FIXTURE Available in 120VAC and 12VAC models PureWhite Pool and Spa LED light xtures offer superior, bright white illumination for your pool. This owner’s manual contains important information on installing and using your new PureWhite Pool and Spa LED light …

3, Always disconnect power to the pool light at the circuit breaker panel before attempting to service the light. Failure to do so could result in serious injury or WARNING! Risk of electrical shock or electrocution Do not, under any circumstances, splice wire underwater or behind the …

6, • Installation of a ground fault circuit interrupter (GFCI) for line voltage models on the lighting circuit with an appropriately rated circuit breaker. • A junction box or low voltage transformer is located at least 8 inches above the maximum pool water level and at least 48 inches fr…

4, J&J Electronics PureWhite 4" Min. 48" Min. 18" Min. Top of Lens to Water Level 8" Min. Junction Box or Low Voltage Transformer to the Max. Water Level of Pool To: GFCI, Circuit Breaker, and Power Source Rigid Conduit #8 AWG Ground Connector Bonding Lug is Located at Rear of Niche C…

7, 1. Disconnect the main electrical switch or circuit breaker and the switch which operates the installed light. 2. Remove the existing light per the original manufacturer’s instructions. Place the light xture on the deck. 3. Leaving the light xture on the deck, cut the light cord. Be su…

8, © 2012 J&J Electronics, Inc. All rights reserved. PureWhite™ is a trademark of and manufactured by J&J Electronics, Inc. All registered and trademarked brands and names are the property of their respective companies. REF. 120712 J&J Electronics | Irvine, California www.jandjpoolspa.…