J. A. Roby ATF727 Owner's Manual

15, J. A. Roby ATF727 15 HOW TO PLUG THE THERMOSTAT DIRECTLY INTO THE TERMINAL BOARD -To plug the thermostat into de terminal board, unscrew the scew position 3 and 5 at the left and insert wire thermostat respectively in them. Switch position: 1: Fans works without thermostat. 0: Fan…

8, 8 CHIMNEY Only use approved chimneys of the same dimensions as the appliance exit. Therefore, you should use 7 inches diameter chimneys for your Atmosphere furnace 727. Chimneys must be tested upon the ULC S629 CSA, UL103 norms. The Atmosphere furnace 7…

11, 11 V ERTICAL INSTALLATION The Atmosphere furnace 727 wood appliance must be installed in accordance with the applicable local laws or the CAN/CSA-B365 norm. Install the chimney following the manufacturer’s instructions. …

5, 5 WARNING Before installing, please take a few minutes to read this handbook. Keep it in a sure place and easily reachable for future references. Not following these instructions could be a cause of property damages, injuries or death. If this appliance is not pr…

6, 6 Always use dried wood. Do not burn green or wet wood. Do not use construction debris such as pieces of 2x4, plywood... If the appliance starts to blush, it's because it is too charged. Do not add fuel. Immediately close the doors and the air intake of the appliance…

9, 9 V ERTICAL INSTALLATION INSIDE A MASONRY CHIMNEY The Atmosphere furnace 727 wood appliance must be installed in accordance with the applicable local laws or the CAN/CSA-B365, ULC S635, ULC S640, UL 1777 norms. Install the chimney following the manufacturer’s…