Gorilla Playsets Blue Ridge Mountaineer 2009 Assembly Manual

64, 5/4 X 2 X 16" LARGE RAY SMALL RAY 5/4 X 2 X 10"1-1/2" WOOD SCREW 1: PREDRILL HOLES IN ALL RAYS WITH A 1/8" DRILL BIT AT 3/4" ON CENTER. 2: CENTER THE 5/4 X 2 X 16" LARGE RAY ONTO THE HALF SUN AND THE ROOF SUPPORT BOARDS AND FASTEN WITH TWO 1-1/2" SCREWS. 3:…

37, STEP 9: END WALL SLIDE MOUNT POST 1: FIND THE 4 X 4 X 40" END WALL SLIDE MOUNT POST. 2: MEASURE 26" INCHES FROM THE FRONT OF THE FRONT CORNER POST AND MARK THE MEASUREMENT ON THE INSIDE OF THE 2 X 4 X 78" ROPE LADDER SUPPORT. 3: USE THREE 2-1/2" WOOD SCREWS TO ATTA…

77, STEP 49: ATTACHING THE FOOTER STRAPS 1: PLACE ONE END OF THE FOOTER STRAP INSIDE THE SIDE OF THE FOOT STAND AND THE OTHER END INSIDE THE FOOTER SUPPORT. 2: ATTACH USING 5/16 X 3/4" HEX BOLTS, 5/16" WASHERS, AND 5/16" LOCK NUTS. 3: DO NOT FULLY TIGHTEN HARDWARE UNTIL SLID…

16, 9 1 4 3 2 5 6 7 8 USE THE RULER TO THE RIGHT TO MEASURE YOUR BOLTS AND SCREWS. PICTURE VIEWS SHOWN ABOVE ARE 1:1 SCALE AND CAN BE USED TO MATCH BOLT AND SCREW SIZES. 5/16 X 4-1/2" HEX BOLT QTY: 27 5/16 X 1-1/2" HEX BOLT QTY: 8 5/16 X 3/4" HEX BOLT QTY: 82 5/16&qu…

74, 1: LOCATE TWO 90 SLIDE SECTIONS. FASTEN THE TWO PIECES TOGETHER ALONG THE RIBS WITH 5/16 X 3/4" HEX BOLTS, 5/16" WASHERS, AND 5/16" LOCK NUTS. 2: WITH THE REMAINING 90 SLIDE SECTION AND THE 90 EXIT SECTION, YOU WILL ASSEMBLE THE SLIDE EXIT. THE SLIDE EXIT IS ASSEMBLED THE…

41, Gorilla Playsets Blue Ridge Mountaineer 2009 A 5/16" WASHER GREEN BRACKET90 5/16" X 1-1/2" HEX BOLT STEP 13: ROCK WALL 1: FASTEN THE 90 GREEN BRACKET TO THE ROCK WALL SIDES WITH 5/16 X 1-1/2" HEX BOLTS AND 5/16" WASHERS. 2: DO NOT FULLY TIGHTEN THE HEX BOLTS INTO THE T-NUTS AT THIS TIME. …