Gorilla Playsets Woodbridge Assembly Manual

11, Page 11 ® General Info to Review Before Installation • Depending on your experience, assembly of Gorilla Playsets can take as little as 6 hours up to 24 hours, depending on size, after inventory of parts; therefore, we recommend you set aside a full two days for assembly. • Identify al…

114, SLAT 5/4 X 3 X 16" BRIDGE RAIL 2" WOOD SCREW STEP 16: BRIDGE RAIL SLATS 1. PRE-DRILL THE 5/4 X 3 X 16" BRIDGE RAIL SLATS ON EACH END WITH A 1/8" DRILL BIT. (SEE TOP IMAGE BELOW) 2. PLACE THE BRIDGE RAIL SLATS 3" FROM THE FACE OF THE CORNER POSTS, AND ATT…

118, Gorilla Playsets Woodbridge CHAIN MUST GO THROUGH TWO BOARDS NO EXCEPTIONS!! A IN A MANNER TO ACHIEVE THE CORRECT GAP. GO UNDERNEATH THE TOWER DECK AND USE A QUICK LINK TO ATTACH THE CHAINS TOGETHER. IF YOU HAVE LOOSE ENDS OF THE CHAINS HANGING DOWN THREAD THEM THROUGH THE QUICK LINK TO KEEP THEM UP AND OUT OF THE WAY. …

36, 5/16 X 4-1/2" HEX BOLT 5/16" WASHER 2 X 4 X 70" DECK SUPPORT COUNTER-SUNK HOLES ON CENTER 2 X 4 X 70" DECK SUPPORT COUNTER-SUNK HOLES ON CENTER REAR OF PLAY SET RIGHT SIDE OF PLAY SET STEP 4: DECK SUPPORTS HOLES FOR CLATTER BRIDGE CHAIN. YOU WILL NEED AN EXTRA PER…

15, Page 15 ® REQUIRED TOOL LIST: ___ Standard or Cordless Drill w/ Phillips Bit (#2 square bit provided) ___ 1/8” Drill Bit ___ 3/8” Drill Bit ___ 1” Spade/Paddle Bit ___ ½” Wrench and Socket ___½” Deep Well Socket ___ 9/16” Deep Well Socket ___ 9/16” Wrench a…

80, 17-3/4" 3/8" X 3-1/2" LAG SCREW 3/8" WASHER 2 X 4 X 47-1/2" SAFETY PANEL BOARD 1: MEASURE 17-3/4" FROM BOTTOM OF THE SANDBOX BOARD ON THE RIGHT SIDE OF THE FORT. MARK THESE POSITIONS ON THE OUTSIDE OF THE CORNER POSTS. 2: ALIGN THE TOP OF THE SAFETY PANEL BOARD WITH …