Gosafe G91I Operation & User’s Manual

6, 6.1 Installation steps and ways Check vehicle state before installation a. Get key from owner and enter car to check appearance and all the systems including ignition, sound, air-condition, door switch, trunk control or original alarm system. If there are some problems, confirm with owne…

25, assisting to control the device. The Sub Management Number should be set as "013423562356". 2. Single click program button 1) If it pop-up "com port fail!" means the COM port is used by other software or not exist. 2) If it pop-up "Send data failed!" mea…

21, 13.VEHICULAR DEVICE CONFIGURATION & SETTING 13.1 Configuration Handset 13.2 Explanation of contents showed in configuration handset 1. Startup display: 2. It will display as following after receiving GSM signal " "shows intensity of GSM signal and it will display &quo…

22, Gosafe G91I 3. It will display as following after receiving GPS signal from more than 4 satellites: " " shows it can position. 13.3 Use configuration handset to configure 13.3.1 SMS Center Number (Message Center Number): Press the "set" button of the handset for a moment after it go…

15, 7.4.3 Connection for MDT-9600 8. Connector J204 f or Camera CM9600I or AD 9600 or HUB Ghub-232 This is RS232 connector which can be used to connect the camera or CAN interface or Analog device or RS232 hub. 8.1 J204 Connections for the Camera Connect the camera directly wit…