OHAUS AV53 Instruction Manual

14, Adventurer Pro EN-11 3.4.2 Navigation The Adventurer Pro menu structure consists of three levels. The top level is the main menu which consists of a number of sub-menus. Enter CALIBRATION SETUP READOUT MODE UNIT PRINT-1 PRINT-2 END LOCKOUT RESET GLP PRINT GLP DATA RS232-2 …

40, Adventurer Pro EN-37 LIMITED WARRANTY Ohaus products are warranted against defects in materials and workmanship from the date of delivery through the duration of the warranty period. During the warranty period Ohaus will repair, or, at its option, replace any compo…

39, EN-36 Adventurer Pro 5.4.2 Connections RS232 Interface Hardware On the rear of the balance, the 9-pin female subminiature D connector COM 1, is provided for interfacing to other devices. The pin connections are shown in the illustration below.…

24, Adventurer Pro EN-21 3.7.3 Readout Auto Zero Allows setting the balance auto zero level setting: .5, 1, 2 or 5 divisions. Balance maintains zero until threshold is exceeded. Filter Allows setting the balance filter level: Low, Medium, High. Co…

22, Adventurer Pro EN-19 3.7 Balance Settings Refer to section 3.4.2 Navigation for information on how to enter and navigate the menus. 3.7.1 Calibration Adventurer Pro balances can be calibrated in two ways: Span calibration or Linearity calibration. Span calibration reset…

27, OHAUS AV53 EN-24 Adventurer Pro Project ID Used to enter a Project ID up to 10 characters. Entering a User ID or Project ID Enter the user or Project ID one character at a time. The character to be entered is highlighted by a blinking cursor (underscore). Press the No button repeat…