OHAUS Pioneer Instruction Manual

11, Pioneer ™ EN-10 Disposal In conformance with the European Directive 2002/96 EC on Waste Electrical and Electronic Equipment (WEEE) this device may not be disposed of in domestic waste. This also applies to countries outside the EU, per their specific requirements. Please dispose o…

8, EN-7 Pioneer ™ 5.0 MAINTENANCE 5.1 Troubleshooting Symptom Possible Cause Remedy Cannot turn on No power to balance Verify connections and voltage. Poor accuracy Improper calibration Unstable environment Perform calibration Move balance to suitable locati…

9, Pioneer ™ EN-8 6. TECHNICAL DATA Ambient conditions – The technical data is valid under the following ambient conditions: Ambient temperature: 10°C to 30°C Relative humidity: 15 % to 80 % at 31°C non-condensing, decreasing linearly to 50% at 40°C Height above sea level: Up to 2…

6, OHAUS Pioneer EN-5 Pioneer ™ 4.2 Calibration Menu [.CAL.] InCal or Span calibration should be performed daily and when the room temperature changes. InCal [InCal] calibrates the balance using an internal mass. Span Calibration [SpaN] uses two weight values: zero and a weight between 50% and 10…

4, EN-3 Pioneer ™ 2.3 Level Balance Level the balance on a firm, steady surface. Avoid locations with excessive air current, vibrations, heat sources or rapid temperature changes. 2.4 Connect Power For use with CSA Certified (or equivalent approved) power so…

3, Pioneer ™ EN-2 2.2 Install Components 0.1g and 0.01g Models 1) Install Wind-Ring (InCal only) 2) Install Pan Support 3) Install Pan 0.001g and 0.0001g Models 1) Install Side Doors - Insert fully into Top Frame then down over retainer. 2) Install Panels - In…