Oilon GT 5 Operation Manual

21, GT02 1408 EN 19 (24) Fault Operating line number Function 6710 Reset alarm relay Relay can be reset through relay output QX, if heat pump has failure data for external system. Failure data at pump remains active. 6711 Reset HP Reset heat pump, if failure is not active. Service/spe…

12, 10 (24) GT02 1408 EN If the feature is sued, note following issues for locating remote control unit. ● Locate the remote control unit to the main living area. ● Choose the location so that sensor can measure room temperature as accurately as possible. Place the remote control unit ideally …

19, Oilon GT 5 GT02 1408 EN 17 (24) 721 / 1021 Heating curve displacement If curve slope is suitable for heating circuit, but room temperature is constantly too low or high in comparison to set value, temperature can be changed from operating lines. ‘+’ adjustment increases circulation setting…

10, 8 (24) GT02 1408 EN Control panel buttons 1 Domestic hot water 6 OK 2 Heating mode 7 Cooling 3 Information 8 Reset 4 Back/ESC 9 Occupancy button 5 Settings knob  Domestic hot water button When this function is on, the heat pump generates domestic hot water automatically according to set settings…

13, GT02 1408 EN 11 (24) 5. Press the OK button to select the operating line and edit its setting. 6. Adjust the setting. Use the settings knob to change the operating line setting. 7. Confirm the change. Press the OK button to confirm your changes. If you mistakenly entered a different …

26, 24 (24) GT02 1408 EN Fuse size (A) 3 x 20 3 x 20 3 x 20 3 x 25 3 x 25 3 x 32 3 x 40 3 x 50 Fuse size, if electrical heater is disabled or set as auxiliary (A) 3 x 10 3 x 10 3 x 16 3 x 16 3 x 16 3 x 16 3 x 20 3 x 25 Electical heater max. capacity (kW/A) 6 / 8,7 6 / 8,7 6 / 8,7 6 / 8,7 6 / 8,7 9 …