KUSSMAUL 091-39-12 Instruction Manual

7, SPECIFICATIONS Input Power: 120 Volt, 50/60 Hz, 3.5 Amperes Input Fuse: 6 ampere, fast blow Output Power - Bat 1 & Bat 2: 12 Volts DC, 15 Amperes Max, Total Output Output Power - Battery Saver: 12 Volts DC, 3 Amperes Max Remote Sensing: Electronic, sense wires not required LED Status In…

2, IMPORTANT SAFETY INSTRUCTIONS I. PERSONAL PRECAUTIONS: 1. Someone should be within range of your voice or close enough to come to your aid when you work near a lead-acid battery. 2. Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes. 3…

4, IV. BATTERY SAVER A 3 ampere Battery Saver is built into the charger. When connected as shown in the installation wiring diagram, loads on battery #1 such as radios and rechargeable hand lights are automatically switched to the Battery Saver when power is applied to the charger. …

5, KUSSMAUL 091-39-12 WIRING I. BATTERY CHARGER WIRING INSTRUCTIONS 1. Refer to Installation Wiring Diagram. 2. Refer to Wiring Specications to determine the recommended wire size and maximum lengths. Using a smaller gauge may cause overheating of the terminal. Additional information is available upon …

3, INTRODUCTION The Auto Charge 2000 is a compact, completely automatic, dual channel battery charger designed for vehicles with two batteries. The charger is ruggedized to withstand the shock and vibration encountered by vehicle mounted equipment. FEATURES I. AUTO CHARGE 2000 BATTERY CHARGE…