Nissan 2001 Maxima AUTOMATIC TRANSAXLE Owner's Manual

261, DIAGNOSTIC PROCEDURE =NFAT0108S02 NOTE: The diagnostic procedure includes inspections for the overdrive control and throttle position switch circuits. 1 CHECK PARK/NEUTRAL POSITION (PNP) SWITCH CIRCUIT (With CONSULT-II) With CONSULT-II 1. Turn ignition switch to “ON” position. (Do not start en…

343, SAT252DA 3. Remove bearing from rear internal gear. SAT253D 4. Remove thrust washer from rear internal gear. SAT254DA 5. Remove bearing from forward one-way clutch. SAT255D 6. Remove forward one-way clutch from forward clutch hub. SAT256D INSPECTION NFAT0163 Rear Internal Gear, Forward Clutch Hub …

20, Nissan 2001 Maxima AUTOMATIC TRANSAXLE CLUTCH AND BAND CHART NFAT0013S03 Shift posi- tion Reverse clutch 5 High clutch 6 For- ward clutch 15 Over- run clutch 17 Band servo For- ward one- way clutch 16 Low one- way clutch 18 Low & reverse brake 19 Lock-up Remarks 2nd apply 3rd release 4th apply P PARK POSI- TION R q q REVERSE POSITIO…

207, 3 CHECK DTC Perform Diagnostic Trouble Code (DTC) confirmation procedure, AT-204. OK or NG OK © INSPECTION END NG © GO TO 4. 4 CHECK TCM INSPECTION 1. Perform TCM input/output signal inspection. 2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.…

361, SAT707J 4. Install viscous coupling — RE4F04W. a. After choosing the side gear washer, tighten down differential cases A and B. Tighten bolts to the specified torque. Refer to AT-356. CAUTION: Make sure that A and B alignment marks are positioned cor- rectly. b. Install viscous coup…

341, SAT150F ASSEMBLY NFAT0160 1. Install D-rings on piston. I Apply ATF to both parts. SAT323F 2. Set and align piston with retainer. I This operation is required in order to engage the protru- sions of piston to return springs correctly. Further procedures are given in “ASSEMBLY”. …