GREAT PLANES EP YAK 55 3D Instruction Manual

11, ❏ 2. Slide the gearbox onto the 10mm square stick in the nose. Secure it with a screw. ❏ 3. Install the prop saver onto the gearbox output shaft. The screws should seat down into the flat spots on the shaft. ❏ 4. Install the ESC as shown. If your ESC has a BEC switch, install it in the prov…

3, the instructions may differ slightly from the photos. In those instances the written instructions should be considered as correct. 3. You must take time to build straight, true and strong. 4. You must use an R/C radio system that is in first-class condition, and a correctly sized motor and …

16, GREAT PLANES EP YAK 55 3D throttle as necessary to maintain your glide path and airspeed. If you are going to overshoot, smoothly advance the throttle (always ready on the right rudder to counteract torque) and climb out to make another attempt.When you're ready to make your landing flare and the model is a fo…

7, ❏ 3. Slide the joiner tube through the fuselage bushings. ❏ 4. Slide the other control horn/spacer onto the joiner tube. Do not glue it in place yet. ❏ 5. Test fit the other stabilator half onto the joiner rod. Lengthen the slot in the stabilator half if necessary to allow it to f…

15, connection between your battery pack and the on/off switch with vinyl tape, heat shrink tubing or special clips suitable for that purpose. ❏ 8. Make sure any servo extension cords you may have used do not interfere with other systems (servo arms, pushrods, etc.). ❏ 9. Balance your propeller…

2, INTRODUCTION................................................................2 AMA ...................................................................................2 SAFETY PRECAUTIONS ..................................................2 LITHIUM BATTERY HANDLING & USAGE..............…