Gree E-TAC Installation And Operation Instructions Manual

10, SYSTEM CONFIGURATION VENTILATION CONTROL The ventilation control lever is located at left side of unit, behind front panel. NOTE: The vent door shipping hardware must be removed before using vent control lever. See See figure 9, When set at CLOSE, only the air inside the room is circulated …

21, Gree E-TAC AP3 Xl 15RD -_ 2WH 4WH BU 16RD(BK) R S 15BU!:_ _! 14YE 12BU C5 6BK HEATER LEGEND AP2 RelayC!_UiU_ard . AP3 Ois_ Cireu_ _ard CI Corn #r_ssor Capacitor C2 U, _ Eiectric Heater Rely Compressor Re_ay M1 Com£ressor Motor M2 Outdoor Fan Motor M3 hdoor Pen Motor OU_UBE Outdoor Coi_ Sensor ROOM SAT …

8, RETROFIT SLEEVE PREPARATION IMPORTANT: Inspect wall sleeve thoroughly prior to installation. Manufacturer does not assume responsibility for costs or damages due to defects in sleeve or for improper installation. ELECTRICAL SHOCK HAZARD Failnre to %llow this warning conld resnlt in personal…

14, TERMINAL CONNECTIONS The wall thermostat terminal block is located behind the front panel and is easily accessible on front of control panel. STATUS LED / / Mana2ememg Wall Themlostat Energy Temfinal Connections Tmminal Connections Fig. 24 - Terminal Connector and Status LED Location UNIT…

15, OPERATION IMPORTANT: When unit is first started_ high humidity conditions can cause condensation to form on discharge grille, Keep doors and windows closed. Room humidity will decrease and moisture will evaporate, TEMP CONTROL FAN, MODE& OPERATION Fig. 26 - E-TAC CONTROLS ABOU…