Tarantula AL.1 Installation Manual

10, Tarantula AL.1 SYSTEM PROGRAMMING - Menu 1 INSTALL MANUAL DIAGNOSTICS AL.1 ALARM STATUS / DIAGNOSTICS ALARM STATUS / DIAGNOSTICS LED FLASHES OUTPUT DIAGNOSTICS 2 LOCK OUTPUT OVERLOAD 3 UNLOCK OUTPUT OVERLOAD 4 TRUNK OUTPUT OVERLOAD 5 STARTER DISABLE OVERLOAD 6 NOT USED 7 AUX 5 OUTPUT OVERLOAD 8 2…

9, SHOCK SENSOR ADJUSTMENTS 3 CHIRPS Press and HOLD the Lock and Unlock buttons Hold both buttons until the siren chirps to confirm the shock sensor setting. (1-10 chirps) NOTE- If no buttons are pressed the Shock Sensor Adjustment Mode will automatically time out after 8 seconds. Each time the lo…

4, Pin 1- Brown Wire- Siren Output (3amp Maximum) Connect this wire to the brown or red wire from the alarm siren. Pin 2- Red/White Wire- Trunk Release This output activates for 0.75 sec when the Trunk Button is held for 5 seconds. Pin 3- White/ Blue Wire- Aux 1 (-250ma Output) This outp…

6, 3 PIN KEYLESS CONNECTOR This connector is used when installing the optional keyless entry feature. If the door lock type of the vehicle is not negative you may need to install a voltage inverter, relays or a door lock module to install this feature. Pin 1- Green Wire- Negative Lock Output Conne…

1, FCC ID NOTICE This device complies with Part 15 of the FCC rules. Operation is s ubject to the following conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including inte rference that may cause undesired operation. CAUTION: Chan…