Rabbit RCM3700 Operation & User’s Manual

93, RCM3700 RabbitCore RCM3700 User’s Manual 91 B.1 RCM3700 Prototyping Board The RCM3700 Prototyping Board included in the RCM3700 Development Kit makes it easy to connect an RCM3700 module to a power supply and a PC workstation for devel- opment. It also provides some basic I/O peripherals (R…

78, RabbitCore RCM3700 User’s Manual 76 restore the monitor, go back to the other window, click back to go to the upload page again, and choose HUMIDITY_MONITOR.ZHTML to replace monitor.ztm, and click Upload. When you refresh the page in your browser, you will see that the page has been res…

74, Rabbit RCM3700 RabbitCore RCM3700 User’s Manual 72 6.5 Run the PINGME.C Sample Program Connect the crossover cable from your computer’s Ethernet port to the RCM3700 board’s RJ-45 Ethernet connector. Open this sample program from the SAMPLES\TCPIP\ICMP folder, compile the program, and start it running …

39, RabbitCore RCM3700 User’s Manual 37 4.5 Memory 4.5.1 SRAM RCM3700 series boards have 256K–512K of SRAM. 4.5.2 Flash EPROM RCM3700 series boards also have 256K–512K of flash EPROM. NOTE: Rabbit recommends that any customer applications should not be constrained by the sector size of the f…

62, RabbitCore RCM3700 User’s Manual 60 5.3 Upgrading Dynamic C Dynamic C patches that focus on bug fixes are available from time to time. Check the Web site www.rabbit.com/support/ for the latest patches, workarounds, and bug fixes. The default installation of a patch or bug fix is to…

95, RCM3700 RabbitCore RCM3700 User’s Manual 93 • RS-232—Three 3-wire serial ports or one 5-wire RS-232 serial port and one 3-wire serial port are available on the Prototyping Board at header J2. A jumper on header JP2 is used to select the drivers for Serial Port E, which can be set eithe…