TDK-Lambda Genesys Series Operation & User’s Manual

22,  OUTPUT:PON 1 Notes: This command is in addition to the SCPI compliance requirements. 2.5.5 REPORT POWER SUPPLY POWER-UP MODE COMMAND Report the Power Supply Auto-Restart or Safe-Start operation upon power up mode. The inter- face will return an ON if the supply is Auto-restart opera…

35,  3. SYSTEM:ERROR MESSAGES The Status and Error Registers described in the previous section is only one of the status methods in the IEEE board. There is also a SCPI requirement for error messages that are in the form of: <Error Number><Comma><Quote><Error Descripti…

11,  HQWHU µ(2, RQ ODVW E\WH¶ ÀDJ  enter end-of-string mode/byte: 10 Program supply to ud0: ibwrt “sour:volt 100” 100 volts output [0100] ( cmpl ) count: 12 Program supply to ud0: ibwrt “sour:curr 5” 5 amps output [0100] ( cmpl ) count: 11 Query:…

36,  +321 “AC fault shutdown” Brown-out or phase-loss shutdown occurred +322 “Over-Temperature shutdown” Over-temperature shutdown occurred +323 “Fold-Back shutdown” Fold-Back shutdown occurred +324 “Over-Voltage shutdown” Over-Voltage shutdown occurred +325…

30,   EVENT REGISTERS: These contain bits that are set when an event or error oc- curs. The bits are cleared when the contents of the register are queried. 2.9.3 CLEAR ALL STATUS REGISTERS *CLS This command clears all event registers and stored error messages. It will not…

15, TDK-Lambda Genesys Series  2.2.6 MEASURE CURRENT COMMAND The output current can be measured by sending the SCPI command: MEASure:CURRent? When the controller does the next IEEE Read, the supply will return the amperes of current being produced Example: MEASURE:CURRENT? 2.2.7 ENABLE THE SUPPLY OUTPUT COMMAND The power …