GSE 675 Manual, User Instructions

42, 40 Model 675 User Instructions 5.2 Hardware Errors Message Description CoDE17 A/D BAD! The processor has detected a problem with the A/D chip. Several situations could cause this error message to be displayed. The most severe situation would be a damaged or defective A/D. In …

38, GSE 675 36 Model 675 User Instructions 3. Press [ENTER] at the Temp Zero? prompt to establish a temporary zero reference. 4. After establishing the temporary zero reference, the default calibration units are displayed momentarily followed by the Keyin CalWT prompt. 5. Apply the calibr…

32, 30 Model 675 User Instructions 3. Add the sample pieces and press the [F1] Accept key to accept the sample. 4. Continue to add pieces to count Without Auto Tare 1. If the sample size is known and a container is used: 1a. Place an empty container on the scale and press [TARE] key. 1b. Place the s…

6, 4 Model 675 User Instructions 1.2 Installation 1.3 Enclosure The enclosure is made of die cast aluminum with rib enforcement. This design provides extra strength and durability. The enclosure is painted with powder coat finish and the counting surface is stainless steel. The enclosure a…

19, Model 675 User Instructions 17 2.1.4 Advanced Setup Menu The Advanced Menu will allow access to the time/date, setup mode and application files. Use the arrow keys to navigate to the desired tab. This is common on the preprogrammed methods of counting such as Quick Count and APW. Time/Date 1. F…

27, Model 675 User Instructions 25 2.3 F3 - GSE Default If the preprogrammed applications are not going to be used, than the Model 675 should be factory defaulted. This mode will reset the Model 675 to GSE factory default status. Note: The preset applications will be lost. The Model 675…