Liebert 610 Installation Manual

24, Configuring Your Neutral and Ground Connections 18 6.5 Grounding Configuration, Corner-Grounded Delta or Impedance-Grounded Wye As previously mentioned, Series 610 SCC requires a bypass input neutral for sensing and monitoring. With a wye-connected input source, the installer should alw…

30, Wiring Considerations 24 7.2 Control Wiring Control wiring must be flexible stranded, tinned copper and run in individual separate steel conduits. Control wiring must be separated from power wiring. In addition, each control wiring cable group should be run in a separate conduit to minimize contr…

76, Liebert 610 Installation Drawings 70 Figure 51 Outline drawing, dual-breaker module battery disconnect, 175-250A, 600VDC circuit breaker 88-797616-17 Rev. 03 …

14, Equipment Location 8 4.0 EQUIPMENT LOCATION 1. Handle cabinet(s) in accordance with the safety precautions in this manual, especially in these sections: • Battery Cabinet Precautions—inside front cover • Important Safety Instructions—page 1 • 2.0 - Unloading and Handlin…

47, Installation Drawings 41 Figure 22 Line-up detail, Single- or Multi-Module System, SpaceSaver with battery cabinets 88-797607-48 Rev. 05 …

10, Installation Considerations 4 10. A breaker coordination study should be performed to ensure proper handling of fault currents. Figure 1 Multi-Module 100 to 225kVA UPS Figure 2 UPS Multi-Module Unit block diagram NOTE The instantaneous trip setting of the breaker feeding the SCC bypass…